Veto Pro Pac VPP-TECH-XL-WHEELER Tech Pac Wheeler Bag XL

The TECH-XL WHEELER is a rolling version of the tried and true TECH-XL tool bag. Featuring additional volume capacity and Veto Pro Pac’s proprietary V-SWAP system, the TECH-XL WHEELER provides a versatile tool storage, organizing and wheeled transport system. The bag comes with innovative V-SWAP removable Tool (mandatory) and Meter pocket panels to allow for customization. Panels are easily swapped out with optional Laptop and Bulk Storage panels, which are available and sold separately.\r\nSpecifications\r\n\r\nHeight (BH): 19in (48cm)\r\nWidth (W): 20in (51cm)\r\nDepth (D): 12.5in (32cm)\r\nHandle Height (HH): 22.5in/57cm\r\nWeight (empty): 18lbs/8 kg\r\nInternal Volume: 2500in3/41L\r\nMax Payload: 100lbs/45kg\r\n\r\nCapacity\r\n\r\nLarge front and back zippered storage bays keep tools safe and secure\r\n85 interior and exterior tool pockets of varying sizes\r\nV-SWAP removable tool pocket panel system with alternate tool panels available and sold separately\r\nFront tool panel includes removable sub-panels for interior customization and storing of larger tools\r\nWaterproof Polypropylene plastic base with integral 5in (13cm) wheels and trolley system\r\nThermoformed protective backside with hinged rub rails\r\nMetal YKK locking zippers\r\n8in Electrical tape strap\r\nT-Bar Tape Roll Chain\r\nInterior gray pockets for better visibility\r\nMagnetic screw catchers\r\n\r\nKeep the Zippers Clean and LubricatedOver time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.\r\nProtect the Zippers From Sharp Objects and/or Excessive HeatAny sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.\r\nDon’t Overstuff the BagOverstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!